John Deere 830 Mower-Conditioner

  • Optional V10 rolls and Wide Swath Kit
  • Modular-design cutterbar
  • Adjustable roll pressure
  • Hydraulic tongue positioning


+ Equal-angle hitch and tongue

+ Rockshaft swivel hitch and tongue

+ Rotary disk cutterbar

+ Modular-design cutterbar

+ Impeller conditioner

+ Urethane roll conditioner available

+ Windrow formation

+ V10 steel roll conditioner

+ Wide swath kit

Power requirements

PTO speed 540 or 1,000 rpm
HP 540 rpm PTO  
HP 1000 rpm 1-3/8 in. PTO 52-112 kW
70-150 hp
HP 1000 rpm 1-3/4 in. PTO  
Powerline type Double-telescoping Grob spline (swivel is tube)
Hydraulic pressure required 13,790 kPa
2,000 psi


Type John Deere
Cutting width 3 m
9.8 ft
Cutting height 2-9.5 cm
0.8-3.7 in.
Number of disks 6
Number of knives 12
Disk speed 2,650 rpm
Knife tip speed 307 km/h
191 mph
Disk drive Gear
Lubrication Hy-Gard oil
Oil reservoir capacity 7 L
7.4 U.S. qt
Cutterbar oil check Combination check, drain plug
Cutterbar angle Adjustable
Angle adjustment Mechanical standard
Angle range  
Cutterbar protection Shearhub
Adjustable gauge shoes Yes


Impeller Width
185 cm
73 in. Diameter
60 cm
23.5 in. Number of V-tines
45 Number of speeds
2 Drive
3-V powerband belt and sheaves Conditioner hood
Adjustable, single hand crank
Rolls Width
185 cm
73 in. Diameter
25.4 cm
10 in. Type of material
Urethane Design
Recessed cleat Speed
664 rpm Drive
Telescoping shaft

Tractor hookup

Standard hitch  
Ball joint equal angle hitch Standard
Rockshaft swivel hitch Optional
Drawbar swivel hitch  


Overall width Transport
3 m
9.8 ft
Overall length Conventional transport
6.3 m
20.6 ft
Weight With urethane roll conditioner
Equal angle: 2,519 kg
5,553 lb With impeller conditioner
Equal angle: 2,376 kg
5,238 lb
Standard tires 11L-15 standard
31x13.5L 15 optional


Are wrenches required for adjusting? Roll pressure
Yes - Roll spacing
Yes - Header tilt

Additional information

Date collected