Traction implement tires make the in-line wrappers sure-footed on wet and uneven terrain to help get the machine where it needs to be for wrapping bales.
The LW11 Series comes standard with the traction implement tires, and they are available on the LW12 Series only when ordered with single- or dual-power drive.
The control box and levers are the control center of the in-line bale wrappers.
A few of the uses are to turn the unit on and off, control the bale ramp, and bale push.
A larger horsepower engine with a high-flow pump provides increased capacity to complete the job faster.
NOTE: LW Series In-Line Baler Wrappers come standard with a 9.7-kW (13-hp) Honda engine.
Honda is a registered trademark of Honda Motor Company.
Optional single- or dual-power drives allow the operator to maneuver the unit without attaching it to a tractor. The single-power drive has one rear tire, while the dual-power drive has two rear tires, to provide traction for the unit. These features are great for wet or uneven ground conditions where traction is limited.
This remote control allows the operator to steer, start, and the stop the machine without using the control panel on the machine.
This kit provides a double layer of wrap, increasing the amount of wrap applied to bales.
The bale follower allows the in-line wrapper to automatically follow the line of bales next to it.
For early morning or late night work, choose between two optional work lights – light-emitting diode (LED) and halogen.
The bale push moves the bale to the back of the bale wrapper. From this point, the operator can utilize the optional bale push off arm to finish the process. The operator moves a lever to extend the arm, and the arm pushes the bale off onto the ground.
The adjustable tongue (hitch) folds neatly out of the way for wrapping. It is located at the opposite end of where the bales are wrapped.
The adjustable tongue makes moving and repositioning the machine a quick and easy task, saving time and money.
The film wrap sensor automatically shuts down the wrapping cycle when the machine runs out of film or breaks.
|Overall machine height||2.7 m|
|Overall machine width||2.7 m|
|Overall machine shipping length||5 m|
|Overall machine length||5.5 m|
|Towing unit minimum weight||1,511.8 kg|
|Round bale diameter||1.7 m|
|Square bale size|
|Quantity||Four (two front, two rear)|
|Size (front)||11L-15 Implement|
|Size (rear)||27x10.5 Traction|
|Engine size||9.7 kW|
|Alternator size, amp||18 amp|
|Type||Electric over hydraulic 12 V|
|Steering||Hydraulic with optional remote control|
|Power drive||Optional, hydraulic single or dual wheel|
|Folding tail gate|
|Lift mechanism||Hydraulic rear axle rotation|
|Hoop speed||Adjustable flow control valve|
|Cycle time||Adjustable with limit switches|
|Wrapping capacity||120 bales per hour|
|Film tensioners||Two aluminum rollers: 76.2 cm|
with stretch: 55 percent
|Bale alignment||Fixed bale guides|
|Bale guide rollers||Two standard|
|Bale pusher||Self-contained scissor linkage|
|Unloading||Manual cross tube|
|Transport safety lights||Standard|
|Markings||SMV and reflectors|
|Safety tow chain||Standard|
© 2020, RDO Equipment Co. All Rights Reserved.